RM0033 Rev 9 1355/1381
RM0033 Revision history
1375
09-Dec-2010
2
(continued)
USB OTG FS
Reworked Section 29.6.4: Host scheduler.
USB OTG HS
Updated Section 30.1: OTG_HS introduction.
Updated Figure 373: USB OTG interface block diagram to remove
GPIO interface and DMA.
Updated Section 30.6.4: Host scheduler.
Updated DNA and PKTDRPSTS bit descriptions in Section :
OTG_HS device endpoint-x interrupt register (OTG_HS_DIEPINTx)
(x = 0..5, where x = Endpoint_number).
Removed DMAEN bit in Section : OTG_HS AHB configuration
register (OTG_HS_GAHBCFG).
Removed GMC bit in Section : OTG_HS device control register
(OTG_HS_DCTL).
Removed OTG_HS_DIEPDMABx and OTG_HS_DOEPDMABx
registers.
Changed SOF to micro-SOF in Figure 376: Updating
OTG_HS_HFIR dynamically.
FSMC
Updated Figure 412: Asynchronous wait during a read access to
remove 2HCLK cycles between data sampling and falling edge of
A[25:0], rising edge of NEx, data transition.
Replaced MEMxHIZ+1 by MEMxHIZ in Figure 417: NAND/PC Card
controller timing for common memory access.
Updated MEMHIZx in FSMC_PMEM2..4 register description.
DEBUG
Modified Section 32.6.2: Boundary scan TAP.
Added DBG_RTC_STOP bit in Section 32.16.4: Debug MCU APB1
freeze register (DBGMCU_APB1_FZ).
Added STM32F2xxx JATAP ID code.
Added Section 33: Device electronic signature.
Table 224. Document revision history (continued)
Date Version Changes
To Next Page
Loading...
Need help?
General
