In this section:
Overview .................................................................................. 3-1
Front-panel reading buffer control ............................................ 3-1
Remote reading buffer programming ....................................... 3-7
Overview
Reading buffers capture measurements, ranges, instrument status, and output state of the Keithley
Instruments 2600B. The 2600B has two default reading buffers for each channel. In addition to the
default buffers, you can create user-defined reading buffers. You can use the reading buffers to
acquire readings.
You can access reading buffers from the front panel or over the remote command interface.
The default reading buffers can store more than 60,000 readings if you enable the options for
timestamps and source values. To store 140,000 readings internally, you can disable the timestamps
and source values.
You can save reading buffers to internal nonvolatile memory in the instrument or to a USB flash drive.
Once you save the reading buffers to a USB flash drive, insert the USB flash drive into the USB port
on your computer to view the data in any compatible data analysis application or to transfer the data
from the USB flash drive to your computer.
Front-panel reading buffer control
The dedicated reading buffers can be configured, stored, and recalled when in local mode operation.
Use the front panel to navigate and configure the reading buffers options and to save and recall
stored readings.
To Next Page
Loading...
Need help?
General
