Tektronix KEITHLEY 2600B Series User Manual

Section 9: TSP command reference Series 2600B System SourceMeter® instrument Reference Manual
9-392 2600BS-901-01 Rev. F/August 2021
Example
print(tsplink.trigger[1].overrun)
If an event was ignored, displays true; if an event was not ignored, displays false.
Also see
tsplink.trigger[N].assert() (on page 9-388)
tsplink.trigger[N].clear() (on page 9-388)
tsplink.trigger[N].mode (on page 9-390)
tsplink.trigger[N].release() (on page 9-393)
tsplink.trigger[N].reset() (on page 9-393)
tsplink.trigger[N].stimulus (on page 9-394)
tsplink.trigger[N].wait() (on page 9-395)
tsplink.trigger[N].pulsewidth
This attribute sets the length of time that the trigger line is asserted for output triggers. This command is not
available on the 2604B, 2614B, or 2634B.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (RW)
Yes
Instrument reset
TSP-Link trigger N reset
Recall setup
Not saved
10e-6 (10 µs)
Usage
width = tsplink.trigger[N].pulsewidth
tsplink.trigger[N].pulsewidth = width
width
The pulse width (in seconds)
N
The trigger line (1 to 3)
Details
Setting the pulse width to 0 (seconds) asserts the trigger indefinitely.
Example
tsplink.trigger[3].pulsewidth = 20e-6
Sets pulse width for trigger line 3 to 20 μs.
Also see
tsplink.trigger[N].release() (on page 9-393)

Tektronix KEITHLEY 2600B Series Specifications

General

Brand	Tektronix
Model	KEITHLEY 2600B Series
Category	Measuring Instruments
Language	English