Tektronix KEITHLEY 2600B Series

Section 9: TSP command reference Series 2600B System SourceMeter® instrument Reference Manual
9-224 2600BS-901-01 Rev. F/August 2021
smuX.measure.filter.enable
This command enables or disables filtered measurements.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (RW)
Yes
Instrument reset
SMU reset
Recall setup
Saved setup
0 (smuX.FILTER_OFF)
Usage
filterState = smuX.measure.filter.enable
smuX.measure.filter.enable = filterState
filterState
The filter status; set to one of the following values:
▪ 0 or smuX.FILTER_OFF: Disables the filter
▪ 1 or smuX.FILTER_ON: Enables the filter
X
SMU channel (for example, smua.measure.filter.enable applies to SMU
channel A)
Details
This command enables or disables the filter.
Example
smua.measure.filter.count = 10
smua.measure.filter.type = smua.FILTER_MOVING_AVG
smua.measure.filter.enable = smua.FILTER_ON
Sets the filter count for SMU channel A to 10.
Sets the filter type to moving average.
Enables the filter.
Also see
Filters (on page 2-66)
reset() (on page 9-177)
setup.recall() (on page 9-197)
smuX.measure.filter.count (on page 9-223)
smuX.measure.filter.type (on page 9-225)
smuX.reset() (on page 9-236)