Tektronix KEITHLEY 2600B Series

Series 2600B System SourceMeter® instrument Reference Manual Section 7: Introduction to TSP operation
2600BS-901-01 Rev. F/August 2021 7-15
smuX.trigger.SOURCE_COMPLETE_EVENT_ID (on page 9-277)
smuX.trigger.SWEEP_COMPLETE_EVENT_ID (on page 9-278)
smuX.trigger.SWEEPING_EVENT_ID (on page 9-278)
SMU calibration
smuX.cal.adjustdate (on page 9-201)
smuX.cal.date (on page 9-202)
smuX.cal.due (on page 9-203)
smuX.cal.lock() (on page 9-204)
smuX.cal.password (on page 9-205)
smuX.cal.polarity (on page 9-205)
smuX.cal.restore() (on page 9-206)
smuX.cal.save() (on page 9-207)
smuX.cal.state (on page 9-208)
smuX.cal.unlock() (on page 9-209)
smuX.contact.calibratehi() (on page 9-209)
smuX.contact.calibratelo() (on page 9-211)
smuX.measure.calibrateY() (on page 9-219)
smuX.source.calibrateY() (on page 9-239)
Status model
The status model is a set of status registers and queues. You can use the following commands to
manipulate and monitor these registers and queues to view and control various instrument events.
status.condition (on page 9-280)
status.measurement.* (on page 9-282)
status.measurement.buffer_available.* (on page 9-284)
status.measurement.current_limit.* (on page 9-285)
status.measurement.instrument.* (on page 9-287)
status.measurement.instrument.smuX.* (on page 9-288)
status.measurement.reading_overflow.* (on page 9-290)
status.measurement.voltage_limit.* (on page 9-292)
status.node_enable (on page 9-293)
status.node_event (on page 9-295)
status.operation.* (on page 9-297)
status.operation.calibrating.* (on page 9-299)
status.operation.instrument.* (on page 9-301)
status.operation.instrument.digio.* (on page 9-303)
status.operation.instrument.digio.trigger_overrun.* (on page 9-305)
status.operation.instrument.lan.* (on page 9-307)
status.operation.instrument.lan.trigger_overrun.* (on page 9-309)
status.operation.instrument.smuX.* (on page 9-311)
status.operation.instrument.smuX.trigger_overrrun.* (on page 9-313)
status.operation.instrument.trigger_blender.* (on page 9-315)
status.operation.instrument.trigger_blender.trigger_overrun.* (on page 9-316)
status.operation.instrument.trigger_timer.* (on page 9-318)
status.operation.instrument.trigger_timer.trigger_overrun.* (on page 9-319)