Series 2600B System SourceMeter® instrument Reference Manual Section 9: TSP command reference
2600BS-901-01 Rev. F/August 2021 9-409
tspnet.tsp.runscript()
This function loads and runs a script on a remote TSP-enabled instrument.
Usage
tspnet.tsp.runscript(connectionID, "script")
tspnet.tsp.runscript(connectionID, "name", "script")
Integer value used as an identifier for other tspnet commands
The name that is assigned to the script
The body of the script as a string
Details
This function is appropriate only for TSP-enabled instruments.
This function downloads a script to a remote instrument and runs it. It automatically adds the
appropriate loadscript and endscript commands around the script, captures any errors, and
reads back any prompts. No additional substitutions are done on the text.
The script is automatically loaded, compiled, and run.
Any output from previous commands is discarded.
This command does not wait for the script to complete.
If you do not want the script to do anything immediately, make sure the script only defines functions
for later use. Use the tspnet.execute() function to execute those functions later.
If no name is specified, the script is loaded as the anonymous script.
Example
tspnet.tsp.runscript(myconnection, "mytest",
"print([[start]]) for d = 1, 10 do print([[work]]) end print([[end]])")
Load and run a script entitled mytest on the TSP-enabled instrument connected with myconnection.
Also see
tspnet.execute() (on page 9-401)
To Next Page
Loading...
Need help?
General
