Tektronix KEITHLEY 2600B Series

Section 9: TSP command reference Series 2600B System SourceMeter® instrument Reference Manual
9-136 2600BS-901-01 Rev. F/August 2021
lan.restoredefaults()
This function resets LAN settings to default values.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Function
Yes
Usage
lan.restoredefaults()
Details
The settings that are restored are shown in the following table.
Settings that are restored to default
Attribute
Default setting
lan.autoconnect
lan.ENABLE
lan.config.dns.address[N]
"0.0.0.0"
lan.config.dns.domain
""
lan.config.dns.dynamic
lan.ENABLE
lan.config.dns.hostname
"K-<model number>-<serial number>"
lan.config.dns.verify
lan.ENABLE
lan.config.duplex
lan.FULL
lan.config.gateway
"0.0.0.0"
lan.config.ipaddress
"192.168.0.2"
lan.config.method
lan.AUTO
lan.config.speed
100
lan.config.subnetmask
"255.255.255.0"
lan.linktimeout
20 (seconds)
lan.lxidomain
0
lan.nagle
lan.DISABLE
lan.timedwait
20 (seconds)
This command is run when lan.reset() is sent.
Example
lan.restoredefaults()
Restores the LAN defaults.
Also see
lan.reset() (on page 9-135)
localnode.password (on page 9-156)