Tektronix KEITHLEY 2600B Series

Section 9: TSP command reference Series 2600B System SourceMeter® instrument Reference Manual
9-400 2600BS-901-01 Rev. F/August 2021
Example 1
instrumentID = tspnet.connect("192.0.2.1")
if instrumentID then
-- Use instrumentID as needed here
tspnet.disconnect(instrumentID)
end
Connect to a TSP-enabled device.
Example 2
instrumentID = tspnet.connect("192.0.2.1", 1394, "*rst\r\n")
if instrumentID then
-- Use instrumentID as needed here
tspnet.disconnect(instrumentID)
end
Connect to a device that is not TSP-enabled.
Also see
localnode.prompts (on page 9-158)
localnode.showerrors (on page 9-162)
tspnet.tsp.abortonconnect (on page 9-407)
tspnet.disconnect() (on page 9-400)
tspnet.disconnect()
This function disconnects a specified TSP-Net session.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Function
No
Usage
tspnet.disconnect(connectionID)
connectionID
The connection ID returned from tspnet.connect()
Details
This function disconnects the two devices by closing the connection. The connectionID is the
session handle returned by tspnet.connect().
For TSP-enabled devices, this aborts any remotely running commands or scripts.
Example
testID = tspnet.connect("192.0.2.0")
-- Use the connection
tspnet.disconnect(testID)
Create a TSP-Net session.
Close the session.
Also see
tspnet.connect() (on page 9-399)