Simultaneous IV measurement during pulse
The KIPulse “Configure” functions optionally accept an extra reading buffer to activate simultaneous
IV measurements during pulsing. Previous usage of passing in a reading buffer or a nil (for no
measurement) is still supported.
KIHighC factory script
The KIHighC factory script is made up of two functions: i_leakage_measure() and
i_leakage_threshold(). These functions are intended to be used when high capacitance mode
is active. Output is generally at a nonzero voltage before calling these functions. These functions can
also be used to step the voltage to zero volts in order to measure the leakage current.
i_leakage_measure() (on page 9-111)
i_leakage_threshold() (on page 9-112)
KIParlib factory script
The KIParlib factory script is made up of two functions: gm_vsweep() and gm_isweep().
gm_vsweep() (on page 9-109)
gm_isweep() (on page 9-108)
KISavebuffer factory script
The KISavebuffer script has one function: savebuffer().
savebuffer() (on page 9-177)
To Next Page
Loading...
