Section 9: TSP command reference Series 2600B System SourceMeter® instrument Reference Manual
9-254 2600BS-901-01 Rev. F/August 2021
Details
During a sweep, the SMU iterates through the arm layer of the trigger model this many times. After
performing this many iterations, the SMU returns to an idle state.
If this count is set to zero, the SMU stays in the trigger model indefinitely until aborted.
Example
smua.trigger.arm.count = 5
Sets the SMU channel A to iterate through the arm layer of the trigger model five times and then return to the
idle state.
Also see
smuX.trigger.count (on page 9-257)
smuX.trigger.arm.set()
This function sets the arm event detector to the detected state.
Usage
smuX.trigger.arm.set()
Source-measure unit (SMU) channel (for example, smua.trigger.arm.set()
applies to SMU channel A)
Details
The SMU automatically clears all the event detectors when the smuX.trigger.initiate()
function is executed. Call this function after the sweep is initiated.
A typical example that uses this function is when you want the SMU to immediately perform an action
the first time through the trigger model, even if a programmed trigger event does not occur.
This function start actions on the SMU if a missed trigger event is missed.
Example
Sets the arm event detector to the detected state for SMU channel A.
Also see
smuX.trigger.initiate() (on page 9-263)
smuX.trigger.measure.set() (on page 9-265)
smuX.trigger.source.set() (on page 9-275)
To Next Page
Loading...
Need help?
General
