Tektronix KEITHLEY 2600B Series

Section 7: Introduction to TSP operation Series 2600B System SourceMeter® instrument Reference Manual
7-18 2600BS-901-01 Rev. F/August 2021
smuX.trigger.SWEEP_COMPLETE_EVENT_ID (on page 9-278)
smuX.trigger.SWEEPING_EVENT_ID (on page 9-278)
trigger.blender[N].clear() (on page 9-368)
trigger.blender[N].EVENT_ID (on page 9-368)
trigger.blender[N].orenable (on page 9-369)
trigger.blender[N].overrun (on page 9-369)
trigger.blender[N].reset() (on page 9-370)
trigger.blender[N].stimulus[M] (on page 9-371)
trigger.blender[N].wait() (on page 9-372)
trigger.clear() (on page 9-373)
trigger.EVENT_ID (on page 9-373)
trigger.generator[N].assert() (on page 9-374)
trigger.generator[N].EVENT_ID (on page 9-374)
trigger.timer[N].clear() (on page 9-375)
trigger.timer[N].count (on page 9-375)
trigger.timer[N].delay (on page 9-376)
trigger.timer[N].delaylist (on page 9-377)
trigger.timer[N].EVENT_ID (on page 9-378)
trigger.timer[N].overrun (on page 9-378)
trigger.timer[N].passthrough (on page 9-379)
trigger.timer[N].reset() (on page 9-379)
trigger.timer[N].stimulus (on page 9-380)
trigger.timer[N].wait() (on page 9-382)
trigger.wait() (on page 9-382)
tsplink.trigger[N].assert() (on page 9-388)
tsplink.trigger[N].clear() (on page 9-388)
tsplink.trigger[N].EVENT_ID (on page 9-389)
tsplink.trigger[N].mode (on page 9-390)
tsplink.trigger[N].overrun (on page 9-391)
tsplink.trigger[N].pulsewidth (on page 9-392)
tsplink.trigger[N].release() (on page 9-393)
tsplink.trigger[N].reset() (on page 9-393)
tsplink.trigger[N].stimulus (on page 9-394)
tsplink.trigger[N].wait() (on page 9-395)
TSP-Link
These functions and attributes allow you to set up and work with a system that is connected by a
TSP-Link
®
network.
The TSP-Link
®
is not available on the 2604B, 2614B, or 2634B. These commands are not available
on those models.
tsplink.group (on page 9-383)
tsplink.master (on page 9-384)
tsplink.node (on page 9-384)
tsplink.readbit() (on page 9-385)