Tektronix KEITHLEY 2600B Series

Series 2600B System SourceMeter® instrument Reference Manual Section 9: TSP command reference
2600BS-901-01 Rev. F/August 2021 9-145
Details
The trigger event detector enters the detected state when an event is detected. This function clears a
trigger event detector and discards the history of the trigger packet.
This function clears all overruns associated with this LAN trigger.
Example
lan.trigger[5].clear()
Clears the event detector with LAN packet 5.
Also see
lan.trigger[N].assert() (on page 9-144)
lan.trigger[N].overrun (on page 9-149)
lan.trigger[N].stimulus (on page 9-151)
lan.trigger[N].wait() (on page 9-152)
lan.trigger[N].connect()
This function prepares the event generator for outgoing trigger events.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Function
Yes
Usage
lan.trigger[N].connect()
N
The LAN event number (1 to 8)
Details
This command prepares the event generator to send event messages. For TCP connections, this
opens the TCP connection.
The event generator automatically disconnects when either the protocol or IP address for this event is
changed.
Example
lan.trigger[1].protocol = lan.MULTICAST
lan.trigger[1].connect()
lan.trigger[1].assert()
Set the protocol for LAN trigger 1 to be multicast when sending LAN triggers. Then, after connecting the LAN
trigger, send a message on LAN trigger 1 by asserting it.
Also see
lan.trigger[N].assert() (on page 9-144)
lan.trigger[N].ipaddress (on page 9-147)
lan.trigger[N].overrun (on page 9-149)
lan.trigger[N].protocol (on page 9-150)
lan.trigger[N].stimulus (on page 9-151)
lan.trigger[N].wait() (on page 9-152)