Tektronix KEITHLEY 2600B Series

Series 2600B System SourceMeter® instrument Reference Manual Section 9: TSP command reference
2600BS-901-01 Rev. F/August 2021 9-137
lan.status.dns.address[N]
This attribute contains the DNS server IP addresses.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (R)
Yes
Not applicable
Not applicable
Not applicable
Usage
dnsAddress = lan.status.dns.address[N]
dnsAddress
DNS server IP address
N
Entry index (1, 2, or 3)
Details
This attribute is an array of DNS server addresses. The instrument can use up to three addresses.
Unused or disabled entries are returned as "0.0.0.0" when read. The dnsAddress returned is a
string specifying the IP address of the DNS server in dotted decimal notation.
You can only specify two addresses manually. However, the instrument uses up to three DNS server
addresses. If two are specified, only the one given by a DHCP server is used. If no entries are
specified, up to three address given by a DHCP server are used.
The value of lan.status.dns.address[1] is referenced first for all DNS lookups. The values of
lan.status.dns.address[2] and lan.status.dns.address[3] are referenced second and
third, respectively.
Example
print(lan.status.dns.address[1])
Outputs DNS server address 1, for example:
164.109.48.173
Also see
lan.status.dns.name (on page 9-137)
lan.status.dns.name
This attribute contains the present DNS fully qualified host name.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (R)
Yes
Not applicable
Not applicable
Not applicable
Usage
hostName = lan.status.dns.name
hostName
Fully qualified DNS host name that can be used to connect to the instrument