Tektronix KEITHLEY 2600B Series User Manual

In this section:
Basic operation ........................................................................ 2-1
Source-measure capabilities .................................................... 2-2
Circuit configurations ................................................................ 2-2
Operation considerations for the ADC ...................................... 2-8
Remote source-measure commands ..................................... 2-10
Triggering in local mode ......................................................... 2-11
Configuring trigger attributes in local mode ............................ 2-12
Configuring for measure-only tests using the MODE key ....... 2-13
Voltmeter and ammeter measurements ................................. 2-14
Ohms measurements ............................................................. 2-15
Power measurements ............................................................ 2-19
Contact check measurements ................................................ 2-22
Multiple SMU connections ...................................................... 2-24
Combining SMU outputs ........................................................ 2-27
Output-off modes ................................................................... 2-40
Range .................................................................................... 2-44
Digits ...................................................................................... 2-49
Speed ..................................................................................... 2-50
Sweep operation .................................................................... 2-51
Relative offset ........................................................................ 2-65
Filters ..................................................................................... 2-66
High-capacitance mode ......................................................... 2-69
Saved setups ......................................................................... 2-75
Basic operation
For the Models 2611B, 2612B, 2614B, 2634B, 2635B, and 2636B, hazardous voltages may be
present on all output and guard terminals. To prevent electrical shock that could cause injury
or death, never make or break connections to the 2600B while the instrument is powered on.
Turn off the equipment from the front panel or disconnect the main power cord from the rear
of the 2600B before handling cables. Putting the equipment into standby does not guarantee
that the outputs are powered off if a hardware or software fault occurs.
Section 2
Sourcing and measuring

Tektronix KEITHLEY 2600B Series Specifications

General

Brand	Tektronix
Model	KEITHLEY 2600B Series
Category	Measuring Instruments
Language	English