bufferVar.n (on page 9-28)
bufferVar.readings (on page 9-29)
bufferVar.sourcefunctions (on page 9-30)
bufferVar.sourceoutputstates (on page 9-31)
bufferVar.sourceranges (on page 9-31)
bufferVar.sourcevalues (on page 9-32)
bufferVar.statuses (on page 9-34)
bufferVar.timestampresolution (on page 9-35)
bufferVar.timestamps (on page 9-36)
savebuffer() (on page 9-177)
smuX.buffer.getstats() (on page 9-199)
smuX.buffer.recalculatestats() (on page 9-201)
smuX.makebuffer() (on page 9-215)
smuX.nvbufferY (on page 9-235)
smuX.savebuffer() (on page 9-236)
Reset
Resets settings to their default settings.
digio.trigger[N].reset() (on page 9-60)
lan.reset() (on page 9-135)
localnode.reset() (on page 9-160)
reset() (on page 9-177)
smuX.reset() (on page 9-236)
timer.reset() (on page 9-367)
trigger.blender[N].reset() (on page 9-370)
trigger.timer[N].reset() (on page 9-379)
tsplink.trigger[N].reset() (on page 9-393)
RS-232
serial.baud (on page 9-189)
serial.databits (on page 9-190)
serial.flowcontrol (on page 9-191)
serial.parity (on page 9-192)
serial.read() (on page 9-193)
serial.write() (on page 9-193)
Saved setups
Use the saved setups commands to save or restore the configurations to or from the nonvolatile
memory of the instrument or an installed USB flash drive. You can use the setup.poweron attribute
to specify which setup is recalled when the instrument is turned on.
setup.poweron (on page 9-196)
setup.recall() (on page 9-197)
setup.save() (on page 9-198)
To Next Page
Loading...
