status.operation.instrument.tsplink.* (on page 9-321)
status.operation.instrument.tsplink.trigger_overrun.* (on page 9-322)
status.operation.measuring.* (on page 9-324)
status.operation.remote.* (on page 9-325)
status.operation.sweeping.* (on page 9-327)
status.operation.trigger_overrun.* (on page 9-328)
status.operation.user.* (on page 9-331)
status.questionable.* (on page 9-333)
status.questionable.calibration.* (on page 9-335)
status.questionable.instrument.* (on page 9-336)
status.questionable.instrument.smuX.* (on page 9-337)
status.questionable.over_temperature.* (on page 9-339)
status.questionable.unstable_output.* (on page 9-341)
status.request_enable (on page 9-342)
status.request_event (on page 9-344)
status.reset() (on page 9-346)
status.standard.* (on page 9-347)
status.system.* (on page 9-349)
status.system2.* (on page 9-351)
status.system3.* (on page 9-353)
status.system4.* (on page 9-355)
status.system5.* (on page 9-357)
Time
bufferVar.basetimestamp (on page 9-18)
bufferVar.collecttimestamps (on page 9-23)
bufferVar.timestampresolution (on page 9-35)
bufferVar.timestamps (on page 9-36)
delay() (on page 9-53)
gettimezone() (on page 9-107)
os.time() (on page 9-169)
settime() (on page 9-194)
settimezone() (on page 9-195)
timer.measure.t() (on page 9-366)
timer.reset() (on page 9-367)
Triggering
The triggering commands allow you to set the conditions that the instrument uses to determine when
measurements are captured. See Sweep operation (on page 2-51) for details on sweeping.
The digio and tsplink commands are not available on the 2604B, 2614B, and 2634B.
digio.trigger[N].assert() (on page 9-55)
digio.trigger[N].clear() (on page 9-56)
digio.trigger[N].EVENT_ID (on page 9-56)
digio.trigger[N].mode (on page 9-57)
To Next Page
Loading...
