Tektronix KEITHLEY 2600B Series - Page 214

Series 2600B System SourceMeter® instrument Reference Manual Section 7: Introduction to TSP operation
2600BS-901-01 Rev. F/August 2021 7-17
digio.trigger[N].overrun (on page 9-58)
digio.trigger[N].pulsewidth (on page 9-59)
digio.trigger[N].release() (on page 9-59)
digio.trigger[N].reset() (on page 9-60)
digio.trigger[N].stimulus (on page 9-61)
digio.trigger[N].wait() (on page 9-62)
display.trigger.clear() (on page 9-84)
display.trigger.EVENT_ID (on page 9-84)
display.trigger.overrun (on page 9-85)
display.trigger.wait() (on page 9-85)
lan.trigger[N].assert() (on page 9-144)
lan.trigger[N].clear() (on page 9-144)
lan.trigger[N].connect() (on page 9-145)
lan.trigger[N].connected (on page 9-146)
lan.trigger[N].disconnect() (on page 9-146)
lan.trigger[N].EVENT_ID (on page 9-147)
lan.trigger[N].ipaddress (on page 9-147)
lan.trigger[N].mode (on page 9-148)
lan.trigger[N].overrun (on page 9-149)
lan.trigger[N].protocol (on page 9-150)
lan.trigger[N].pseudostate (on page 9-150)
lan.trigger[N].stimulus (on page 9-151)
lan.trigger[N].wait() (on page 9-152)
smuX.trigger.arm.count (on page 9-253)
smuX.trigger.arm.set() (on page 9-254)
smuX.trigger.arm.stimulus (on page 9-255)
smuX.trigger.ARMED_EVENT_ID (on page 9-256)
smuX.trigger.autoclear (on page 9-257)
smuX.trigger.count (on page 9-257)
smuX.trigger.endpulse.action (on page 9-259)
smuX.trigger.endpulse.set() (on page 9-259)
smuX.trigger.endpulse.stimulus (on page 9-261)
smuX.trigger.endsweep.action (on page 9-262)
smuX.trigger.IDLE_EVENT_ID (on page 9-263)
smuX.trigger.initiate() (on page 9-263)
smuX.trigger.measure.action (on page 9-264)
smuX.trigger.measure.set() (on page 9-265)
smuX.trigger.measure.stimulus (on page 9-266)
smuX.trigger.measure.Y() (on page 9-268)
smuX.trigger.MEASURE_COMPLETE_EVENT_ID (on page 9-269)
smuX.trigger.PULSE_COMPLETE_EVENT_ID (on page 9-269)
smuX.trigger.source.action (on page 9-270)
smuX.trigger.source.limitY (on page 9-271)
smuX.trigger.source.linearY() (on page 9-272)
smuX.trigger.source.listY() (on page 9-273)
smuX.trigger.source.logY() (on page 9-274)
smuX.trigger.source.set() (on page 9-275)
smuX.trigger.source.stimulus (on page 9-276)
smuX.trigger.SOURCE_COMPLETE_EVENT_ID (on page 9-277)