Tektronix KEITHLEY 2600B Series User Manual

Section 9: TSP command reference Series 2600B System SourceMeter® instrument Reference Manual
9-156 2600BS-901-01 Rev. F/August 2021
localnode.model
This attribute stores the model number.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (R)
Yes
Not applicable
Not applicable
Not applicable
Usage
model = localnode.model
model
The model number of the instrument
Example
print(localnode.model)
Outputs the model number of the local node. For example:
2602B
Also see
localnode.serialno (on page 9-161)
localnode.password
This attribute stores the remote access password.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (W)
Yes
LAN reset
LAN restore defaults
Nonvolatile memory
""
Usage
localnode.password = "password"
password
A string that contains the remote interface password, up to 255 characters
Details
This write-only attribute stores the password that is set for any remote interface. When password
usage is enabled (localnode.passwordmode), you must supply a password to change the
configuration or to control an instrument from a remote command interface.
The instrument continues to use the old password for all interactions until the command to change it
executes. When changing the password, give the instrument time to execute the command before
attempting to use the new password.
You cannot retrieve a lost password from any command interface.
You can reset the password by resetting the LAN from the front panel or by sending the
lan.reset() command.
When using this command from a remote node, localnode should be replaced with the node
reference, for example, node[5].password.

Tektronix KEITHLEY 2600B Series Specifications

General

Brand	Tektronix
Model	KEITHLEY 2600B Series
Category	Measuring Instruments
Language	English