Section 3: Reading buffers Series 2600B System SourceMeter® instrument Reference Manual
3-10 2600BS-901-01 Rev. F/August 2021
Commands to store readings
Makes voltage measurements; stores readings in
rbuffer.
Makes current measurements; stores readings in
rbuffer.
smuX.measure.iv(ibuffer, vbuffer)
Makes both current and voltage measurements; stores
current readings in ibuffer and stores voltage
readings in vbuffer.
Makes resistance measurements; stores readings in
rbuffer.
Makes power measurements; stores readings in
rbuffer.
smuX.trigger.measure.v(rbuffer)
Configures voltage measurements to be made during a
sweep, including where readings are stored (rbuffer).
smuX.trigger.measure.i(rbuffer)
Configures current measurements to be made during a
sweep, including where readings are stored (rbuffer).
smuX.trigger.measure.r(rbuffer)
Configures resistance measurements to be made during
a sweep, including where readings are stored
(rbuffer).
smuX.trigger.measure.p(rbuffer)
Configures power measurements to be made during a
sweep, including where readings are stored (rbuffer).
smuX.trigger.measure.iv(ibuffer,
vbuffer)
Configures both current and voltage measurements to be
made during a sweep, including where readings are
stored; current readings are stored in ibuffer and
voltage readings are stored in vbuffer.
Commands to access readings
printbuffer(start_index, end_index,
st_1, st_2, ... st_n)
Prints data from buffer subtables:
â–ª start_index (starting index of values to print)
â–ª end_index (ending index of values to print)
â–ª st_1, st_2, ... st_n (subtables from which to
print, each separated by a comma)
* smuX can be smua for channel A or smub for channel B
To Next Page
Loading...
Need help?
General
