Tektronix KEITHLEY 2600B Series

Series 2600B System SourceMeter® instrument Reference Manual Section 6: Troubleshooting guide
2600BS-901-01 Rev. F/August 2021 6-3
Error summary
Error number
Error level
Error message
601
RECOVERABLE
Reading buffer data lost
603
RECOVERABLE
Power on state lost
702
FATAL
Unresponsive digital FPGA
802
RECOVERABLE
OUTPUT blocked by interlock
819
RECOVERABLE
Error parsing exponent
820
RECOVERABLE
Error parsing value
900
FATAL
Internal system error
1100
RECOVERABLE
Command unavailable
1101
RECOVERABLE
Parameter too big
1102
RECOVERABLE
Parameter too small
1103
RECOVERABLE
Min greater than max
1104
RECOVERABLE
Too many digits for param type
1105
RECOVERABLE
Too many parameters
1107
RECOVERABLE
Cannot modify factory menu
1108
RECOVERABLE
Menu name does not exist
1109
RECOVERABLE
Menu name already exists
1110
FATAL
Analog supply failure: over temperature
1113
RECOVERABLE
Data too complex
1122
SERIOUS
Interlock or power supply failure
1200
RECOVERABLE
TSP-Link initialization failed
1202
RECOVERABLE
TSP-Link initialization failed
1203
RECOVERABLE
TSP-Link initialization failed (possible loop in node chain)
1204
RECOVERABLE
TSP-Link initialization failed
1205
RECOVERABLE
TSP-Link initialization failed (no remote nodes found)
1206
RECOVERABLE
TSP-Link initialization failed
1207
RECOVERABLE
TSP-Link initialization failed
1208
RECOVERABLE
TSP-Link initialization failed
1209
RECOVERABLE
TSP-Link initialization failed
1210
RECOVERABLE
TSP-Link initialization failed (node ID conflict)
1211
RECOVERABLE
Node NN is inaccessible
1212
RECOVERABLE
Invalid node ID
1213
RECOVERABLE
TSP-Link session expired
1215
RECOVERABLE
Code execution requested within the local group
1216
RECOVERABLE
Remote execution requested on node in group with pending overlapped
operations
1217
RECOVERABLE
Remote execution requested on node outside the local group
1218
RECOVERABLE
Operation allowed only when TSP-Link master
1219
RECOVERABLE
TSP-Link found fewer nodes than expected
1400
RECOVERABLE
Expected at least NN parameters
1401
RECOVERABLE
Parameter NN is invalid
1402
RECOVERABLE
User scripts lost
1403
RECOVERABLE
Factory scripts lost
1404
RECOVERABLE
Invalid byte order
1405
RECOVERABLE
Invalid ASCII precision
1406
RECOVERABLE
Invalid data format
1500
RECOVERABLE
Invalid baud rate setting
1501
RECOVERABLE
Invalid parity setting
1502
RECOVERABLE
Invalid terminator setting
1503
RECOVERABLE
Invalid bits setting
1504
RECOVERABLE
Invalid flow control setting