Series 2600B System SourceMeter® instrument Reference Manual Section 6: Troubleshooting guide
2600BS-901-01 Rev. F/August 2021 6-5
TSPnet invalid reading buffer index range
TSPnet feature only supported on TSP connections
TSPnet must specify both port and init
TSPnet disconnected by other side
TSPnet read input buffer overflow
Termination locked while using TSP connection
Average delay must be at least NNN seconds
Reading buffer index NN is invalid
ICX parameter count mismatch, %s (Line #%d)
ICX parameter invalid value, %s (Line #%d)
ICX invalid function id, %s (Line #%d)
SMU is unresponsive. Disconnect DUT and cycle power
Saved calibration constants corrupted
Operation conflicts with CALA sense mode
Operation would exceed safe operating area of the instrument
Operation not permitted while OUTPUT is on
Unknown sourcing function
Operation not permitted while cal is locked
Cal data not saved - save or restore before lock
Cannot save cal data - unlock before save
Cannot restore cal data - unlock before restore
Save to cal set disallowed
Cannot change cal date - unlock before operation
Cannot change cal constants - unlock before operation
Cal version inconsistency
Cannot unlock - invalid password
Cannot restore default calset. Using previous calset
Cannot restore previous calset. Using factory calset
Cannot restore factory calset. Using nominal calset
Cannot restore nominal calset. Using firmware defaults
Cannot set filter.count > 1 when measure.count > 1
Unlock cal data with factory password
Cannot perform requested operation while source autorange is enabled
Cannot save without changing cal adjustment date
Cannot change this setting unless buffer is cleared
Reading buffer not found within device
Index exceeds maximum reading
Output Enable not asserted
Cannot perform requested action while an overlapped operation is in
progress
Cannot perform requested operation while voltage measure autorange is
enabled
Cannot perform requested operation while current measure autorange is
enabled
Cannot perform requested operation while filter is enabled
Minimum timestamp resolution is 1us
To Next Page
Loading...
Need help?
General
