EasyManua.ls Logo

Xerox WORKCENTRE 3210

Xerox WORKCENTRE 3210
416 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
WorkCentre 3210/3220 Multifunction Printer Service Manual I – 5
Print Cartridge
cleaning, 7-3
components, 2-17
consumables, 1-11
CRUM, 2-17
drive, 2-13
drum cleaning page, 7-6
errors, 3-6
ghosting image, 5-15
jam in OPC, 4-16
life count, 1-11
low toner, 5-4
non-Xerox Print Cartridge, 1-23
OPC drum cleaning, 5-38
operation, 2-17
part number, 9-5
removal, 8-8
status messages, 3-37
Print speed, 1-13
Printable area, 1-18
Printer
cleaning, 7-2
clear counts, 4-6
component life, 1-10
defect definitions, 5-9
dimensions, 1-19
electrical requirements, 1-17
error reporting, 3-2
image area, 5-40
image defects, 5-6
installation clearances, 1-19
life count, 1-12
media path, 2-3
moving, 1-x
no output, 4-18
no power, 4-24
noise, 5-39
operating environment, 1-17
power consumption, 1-17
power save, 1-24
print quality defects, 5-2
print speed, 1-13
restart, 4-9
serial number, 9-2
status messages, 3-37
surface reauirements, 1-20
system connections, 1-5
wiring, 10-12
printer
overview, 2-2
Print-quality
defects, 5-9
specifications, 5-39
troubleshooting, 5-9
Protocol Report, 4-10
R
Rear Cover, 1-5
part number, 9-5
removal, 8-61
Rear Guide Assembly
removal, 8-97
Registration Clutch, 2-28
part number, 9-12
removal, 8-71
wiring, 10-16
Registration Roller
removal, 8-73
Registration Sensor
wiring, 10-16
Registration Sensor, Duplex Sensor, 2-27
Repeating defects, 5-10
Reports
configuration, 4-10
customer reports, 1-24
error information report, 3-2
protocol, 4-10
supplies information, 4-11
supplies report, 1-25
usage, 4-11
Restart, 4-9
Right Cover
part number, 9-5
removal, 8-62
Roller
feed roller, 2-7
heat roller, 2-15, 2-33
image defects, 5-10
media damage, 5-33
pick up roller, 2-7
pressure rollers, 2-15
tray pick up, 2-7
ROM test, 4-8
S
Safety
precautions, v
service, vii
symbols, iv
Scanner, 2-12
cleaning, 7-5
components, 2-12
driver, 1-14
image spots, 5-32
image streaks, 5-31
magnification error, 5-30
malfunction, 4-19
maximum image area, 1-14
noise specification, 5-39
output formats, 1-14
part number, 9-19
removal, 8-48
resolution, 1-12

Table of Contents

Other manuals for Xerox WORKCENTRE 3210

Related product manuals