Austro Engine E4 Series - Page 524

E4 Series
Maintenance Manual
Reciprocating
Engine
Page 236
E4.08.04
Rev. 29
85-Maintenance Procedures
01-Jul-2020
Detail Steps/Work Items
Key Items/References
(17)
Make sure that the balancing weights are not
loose or missing.
Make sure that the weld points are not
broken.
If the balancing weights are missing
(you can see the weld points without
the balancing weights), replace the
two-mass flywheel.
If the weld points are broken,
replace the two-mass flywheel.
Refer to Fig. 85 - 65.
Visual Inspection performed:
FITTER
(Name, Date, Signature)
INSPECTOR
(Name, Date, Signature)
Fig. 85 - 50 Friction Control Cam / Rear side of the primary mass
Molten plastic