Enter/Exit Programming Mode Enable EAN Two Label
154 Magellan™ 3450VSi
Enable EAN Two Label
Enables/disables the ability of the scanner to decode EAN two-label pairs.
To set this feature:
1. Scan the Enter/Exit Programming
Mode bar code.
2. Scan either the enable or disable bar code below. You’
ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by
scanning the Enter/Exit Pro-
gramming Mode bar code.
NOTE
DEFAULT
EAN Two Label = Disable
EAN Two Label = Enable
Contact Customer Support for details about advanced program-
ming for this feature.
To Next Page
Loading...
