Product Reference Guide 297
Appendix D
Factory Default Settings
The following table provides a listing of the most common factory settings for
the interfaces shown.
NOTE
Some of the individual interfaces list
ed in the defaults table below
appear in the same column since they share similar feature set-
tings with few (if any) exceptions.
Keep in mind though, that the actual
configuration storage area for
each interface is unique and that updates & changes to factory
defaults can be made at any time without notice.
Factory Default Settings
Feature
Default
Master
RS-232
RS-232
Wincor-
Nixdorf
RS-232
Single
Cable
Keyboard
USB COM
/
USB TEC
USB OEM
General Scanner Features
1D Double Read Time-
out on page 12
28 (400ms) 28 (400ms) 28 (400ms) 28 (400ms) 28 (400ms) 28 (400ms) 28 (400ms)
2D Double Read Time-
out on page 13
46 (700ms) 46 (700ms) 46 (700ms) 46 (700ms) 46 (700ms) 46 (700ms) 46 (700ms)
Digital Watermark
(DWM) Enable on page
14
01 (enable) 01 (enable) 01 (enable) 01 (enable) 01 (enable) 01 (enable) 01 (enable)
Digital Watermark
(DWM) Double Read
Timeout on page 15
0.5 Sec. 0.5 Sec. 0.5 Sec. 0.5 Sec. 0.5 Sec. 0.5 Sec. 0.5 Sec.
Digital Watermark
(DWM) Data Format on
page 16
00
(compatibility
mode)
00
(compatibil
ity mode)
00
(compatibil
ity mode)
00
(compatibil
ity mode)
00
(compatibil
ity mode)
00
(compatibil
ity mode)
00
(compatibility
mode)
Sleep Mode Timer on
page 17
5 minutes 5 minutes 5 minutes 5 minutes 5 minutes 5 minutes 5 minutes
1D Inverse Read Con-
trol on page 18
0000 (disable)
0000
(d
isable)
0000
(disable)
0000
(disable)
0000
(disable)
0000
(disable)
0000 (disable)
2D Inverse Read Con-
trol on page 19
00 (disable)
00
(d
isable)
00
(disable)
00
(disable)
00
(disable)
00
(disable)
00 (disable)
Illumination During
Disable Mode on page
20
01 (enable) 01 (enable) 01 (enable) 01 (enable) 01 (enable) 01 (enable) 01 (enable)
To Next Page
Loading...
