Datalogic Magellan 3450VSi - GS1 QR Code Enable

Enter/Exit Programming Mode QR Code URL Link Enable
274 Magellan™ 3450VSi
GS1 QR Code Enable
This feature controls the ability of the scanner to decode GS1 QR Code labels.
To set this feature:
1. Scan the Enter/Exit Programming
Mode bar code.
2. Scan either the enable or disable bar code below. You’
ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by
scanning the Enter/Exit Pro-
gramming Mode bar code.
DEFAULT
047500(CR)
GS1 QR Code = Disable
047501(CR)
GS1 QR Code = Enable