Datalogic Magellan 3450VSi - I 2 of 5 Check Character Calculation

I 2 of 5 Check Character Calculation Enter/Exit Programming Mode
Product Reference Guide 209
I 2 of 5 Check Character Calculation
Enables/disables calculation and verification of an optional Interleaved 2 of 5
check character.
NOTE
If check character calculation is disabled, the risk is increased that
a
misread can occur. When disabled, any check characters in a bar
code are treated as data characters.
1. To set this feature:
2. Scan the ENTER/EXIT Prog
ramming Mode bar code.
3. Scan either the enable or disable bar code below. You’
ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
4. Complete the programming sequence
by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
DEFAULT
007000(CR)
I 2 of 5 Check Character Calculation = Disable
007001(CR)
I 2 of 5 Check Character Calculation = Enable