ERI Timeout Enter/Exit Programming Mode
Product Reference Guide 25
ERI Timeout
Specifies the amount of time the External Read Indicator (ERI) signal is held
active for a good read. Sets the ERI timeout duration using hex values from 000
to 255 in increments of ten milliseconds (10ms or 0.01 seconds).
To configure this feature:
1. Scan the “Enter/Exit Programming Mode” bar code above to place the unit
in Programming Mode.
2. Scan “Set ERI Timeout,” followed by the two digits (zero padded) from the
Alpha-Numeric Keypad in Appendix C representing the desi
red time value.
3. Exit programming mode by
scanning the “Enter/Exit Programming Mode”
bar code again.
Set ERI Timeout
DEFAULT
Default setting for this feature is:
002 -20ms
To Next Page
Loading...
