Enter/Exit Programming Mode Code 128 Length 1
204 Magellan™ 3450VSi
Code 128 Length 1
If Code 128 Length Control is set to Fixed-Length decoding, this feature speci-
fies Code 128 first fixed length. If Code 12
8 Length Control is set to Variable-
Length decoding, this feature specifies the minmum label length.
To set this feature:
1. Scan the ENTER/EXIT Prog
ramming Mode bar code.
2. Scan the bar code, Set Code 128 Length 1 on page 204 below. You’ll need
to cover any unused bar codes on this and the facing pag
e to ensure that
the scanner reads only the bar code you intend to scan.
3. Scan the appropriate digits from the Alpha-Numeric Keypad in Appendix C
that represent the desired l
abel length. The selectable range for this
option is 01 to 80. Pad all single digit numbers with a leading zero to yield
a two-digit entry (01-80).
4. Complete the programming sequence
by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
Set Code 128 Length 1
DEFAULT
Default setting for this feature = 01
To Next Page
Loading...
