Handheld Data Format Requirements General
332 Magellan™ 3450VSi
Datalogic Handheld Data Format Requirements
The following sections describe label transmission formats that are typically
observed in factory configurations of Datalogic handheld scanners.
GS1 DataBar Omnidirectional
• Prefix must be ASCII characters ‘R4’
• Check character must be included in label
• Application identifier “01” must follow the prefix and preceed the base
label
• Label length excluding prefix characters must be 16 characters.
• Example: ‘R40101044123456789’
GS1 DataBar Expanded
• Prefix must be ASCII characters ‘R4’
• Check character must be included in label
UPC-A
• Number system must be included in label data.
• Check digit must be included in label data and is assumed to be correct.
• Prefix must be an ASCII character 'A' - total length including prefix must
be 13.
• Example: 'A060992011187'.
UPC-A with 2-Digit Supplemental
• Number system must be included in label data.
• Check digit must be included in label data and is assumed to be correct.
• Supplemental data is appended to base label.
• Prefix must be an ASCII character 'A' - total length including prefix must
be 15.
• Example: 'A06099201118712'.
UPC-A with 5-Digit Supplemental
• Number system must be included in label data
• Check digit must be included in label data and is assumed to be correct
• Prefix must be an ASCII character 'A' - total length including prefix must
be 18
• Example: 'A06099201118712345'
UPC-E
• Number system must be included in label data
• Check digit must be included in label data and is assumed to be correct
• Prefix must be an ASCII character 'E' - total length including prefix must be
9
• Example: 'E09988750'
UPC-E with 2-Digit Supplemental
• Number system must be included in label data.
• Check digit must be included in label data and is assumed to be correct.
To Next Page
Loading...
