EasyManuals Logo

Datalogic Magellan 3450VSi User Manual

Datalogic Magellan 3450VSi
352 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #76 background imageLoading...
Page #76 background image
Enter/Exit Programming Mode RS-232 Intercharacter Delay
66 Magellan™ 3450VSi
RS-232 Intercharacter Delay
Specifies delay between the end of one character and the beginning of the next
in 10-millisecond increments. This delay is inserted after each data character
transmitted. If the transmission speed is too high, the system may not be able
to receive all characters. You may need to adjust the delay to make the system
work properly.
To set the RS-232 Intercharacter Delay:
1. Scan the Enter/Exit Programming
Mode bar code.
2. Scan the bar code below, Se
t RS-232 Intercharacter Delay.
3. Scan the appropriate digits from the Alpha-Numeric Keypa
d in Appendix C
that represent the desired del
ay. The selectable range is 0-100, which is
the delay in 10-millisecond increments. Pad all single and double digit
numbers with leading zeroes to yield a three-digit entry (000-100).
Examples:
001 = 10ms
005 = 50ms
040 = 400ms
100 = 1,000ms (1 second)
4. The scanner will automatically exit Programming Mode when the appro-
priate amount of digits
have been scanned.
009C(CR)
Set RS-232 Intercharacter Delay
DEFAULT
Default setting for this feature is:
00 - No Intercharacter Delay

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Datalogic Magellan 3450VSi and is the answer not in the manual?

Datalogic Magellan 3450VSi Specifications

General IconGeneral
Standard interfacesRS-232
Connectivity technologyWired
TypeFixed bar code reader
Sensor typeLED
Scanner type1D/2D
Read rate (max)39000000 reads/s
Yaw reading angle-75 - 75 °
Tilt reading angle0 - 360 °
Pitch reading angle-65 - 65 °
Light levels (direct sunlight)0 - 86000 lx
Linear (1D) barcodes supported-
2D (matrix & stacked) barcodes supportedAztec Code, Data Matrix, MaxiCode, QR Code
Input voltage100-240 V
Input frequency50-60 Hz
Power source typeAC
Power consumption (standby)2.6 W
Power consumption (typical)3 W
Storage temperature (T-T)-40 - 70 °C
Operating temperature (T-T)0 - 40 °C
Operating relative humidity (H-H)5 - 95 %
Product colorBlack
International Protection (IP) codeIP52
Sustainability certificatesRoHS
Harmonized System (HS) code84716070
Weight and Dimensions IconWeight and Dimensions
Depth94 mm
Width152 mm
Height137 mm
Weight600 g

Related product manuals