Datalogic Magellan 3450VSi - Digital Watermark (DWM) Double Read Timeout

Digital Watermark (DWM) Features Enter/Exit Programming Mode
Product Reference Guide 15
Digital Watermark (DWM) Double Read Timeout
Specifies the minimum allowable time which must pass before reading the
same Digital Watermark (DWM) label again (e.g. two identical items in succes-
sion).
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and
the facing page to ensure that the scanner
reads only the bar code you intend to scan.
Complete the programming sequence by sca
nning the Enter/Exit Programming
Mode bar code.
NOTE
00521E(CR)
DWM Double Read Timeout = 0.3 Seconds
005228(CR)
DWM Double Read Timeout = 0.4 Seconds
DEFAULT
005232(CR)
DWM Double Read Timeout = 0.5 Seconds
005246(CR)
DWM Double Read Timeout = 0.7 Seconds
005264(CR)
DWM Double Read Timeout = 1 Second
If the incidence of multiple reads is not acceptable, increase the
Double Read Timeout setting to a higher value.