Enter/Exit Programming Mode Standard 2 of 5 Check Character Calculation
248 Magellan™ 3450VSi
Standard 2 of 5 Check Character Calculation
Enables/disables calculation and verification of an optional Standard 2 of 5
check character.
NOTE
If check character calculation is disabled, the risk is increased that
a misrea
d can occur. When disabled, any check character in a bar
code is treated as data character.
To set this feature:
1. Scan the ENTER/EXIT Prog
ramming Mode bar code.
2. Scan either the enable or disable bar code below. You’
ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence
by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
DEFAULT
Standard 2 of 5 Check Character Calculation = Disable
Standard 2 of 5 Check Character Calculation = Enable
To Next Page
Loading...
