Enter/Exit Programming Mode Aztec Length Control
280
Magellan™ 3450VSi
Aztec Length 1, Length 2 Programming Instructions
If Aztec Length Control is set to Fixed-Length decoding, this feature specifies
Aztec first fixed length. If Aztec Length Control is set to Variable-Length
decoding, this feature specifies the minimum label length.
NOTE
Length 1 is the minimum label length if in variable length mode, or the
first
fixed length if in fixed length mode. Length 2 is the maximum label
length if in variable length mode, or the second fixed length if in fixed
length mode. Length includes the bar code's data characters only. Any
value > 3700 will be considered to be 3700.
To set this feature:
1. Scan the ENTER/EXIT Prog
ramming Mode bar code.
2. Scan the bar code, Set Aztec Length 1 on page 280 or Set Aztec Length 2
on page 280 below. You’ll need to cover any unused bar codes on
this and
the facing page to ensure that the scanner reads only the bar code you
in
tend to scan.
3. Scan the appropriate digits from the Alpha-Numeric Keypa
d in Appendix C
that represent the desired l
abel length. The selectable range for this
option is 0001 to 3700. Pad all numbers with leading zeros to yield a four-
digit entry (0001-3700).
4. Complete the programming sequence
by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
Default setting for this feature = 0001
Set Aztec Length 1
Set Aztec Length 2
Default setting for this feature = 0E74
To Next Page
Loading...
