Sleep Mode Timer Enter/Exit Programming Mode
Product Reference Guide 17
Sleep Mode Timer
This feature specifies the amount of time of inactivity (with no label reads)
before the scanner enters sleep mode.
To set this feature:
1. Scan the Enter/Exit Progr
amming Mode bar code.
2. Scan the bar code, Set Sleep Mode Timer on page 17 below. You’ll need to
cover any unused bar codes on this and the f
acing page to ensure that the
scanner reads only the bar code you intend to scan.
3. Scan the appropriate digits from the Alpha-Numeric Keypa
d in Appendix C
that represent the desired time interva
l. The selectable range is 000-255
in 15 second increments. Pad all numbers with leading zeros to yield a
three-digit entry (000-255).
4. Scan the Enter/Exit Programming Mode
bar code to exit Programming
Mode.
Set Sleep Mode Timer
DEFAULT
Default setting for this feature is: 5 minutes
To Next Page
Loading...
Need help?
General
Weight and Dimensions
