Datalogic Magellan 3450VSi - Good Read When to Indicate

Enter/Exit Programming Mode Good Read When to Indicate
32 Magellan™ 3450VSi
Good Read When to Indicate
This feature specifies when the scanner will provide indication (beep and/or
flash its green LEDs) upon successfully reading a bar code.
• Good Read = Indicate
after decode.
• Good Read = Indicate after transmit.
• Good Read = Indicate after CTS goes inactive, then active.
This mode applies to RS-232 STD and RS-232 WN interfaces only. If set in
ot
her interfaces, “Indicate after decode” mode will be implemented.
• Good Read = Indicate after eac
h output structure proofed.
When beeping after each output structure decoded, if there are multiple
ou
tput structures, there is a delay after the beep has finished. This delay is
equal to the Good Read Beep Length on page 30
.
To set the Good Read When to Indicate feature:
1. Scan the Enter/Exit Programming
Mode bar code.
2. Scan the desired mode bar code from th
ose provided below You’ll need to
cover any unused bar codes on facing pages to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by
scanning the Enter/Exit Pro-
gramming Mode bar code.
DEFAULT
009900(CR)
Good Read When to Indicate = After Decode
009901(CR)
Good Read When to Indicate = After Transmit
009902(CR)
Good Read When to Indicate = After CTS goes Inactive,
Then Active
009903(CR)
Good Read When to Indicate = After Each Output
Structure Proofed