Datalogic Magellan 3450VSi - USB-COM Interface Setup; Interface Selection

Interface Type Enter/Exit Programming Mode
Product Reference Guide 57
USB-COM Interface Setup
The scanner has two USB-COM interfaces, USB-COM and USB-COM DL (Data-
logic). The Datalogic USB-COM driver works for both USB-COM interfaces.
Before plugging your scanner into the Host PC, please ensure you have already
c
opied the executable DLS USB-COM driver file to your PC and that the scan-
ner’s interface is set to USB COM or USB COM DL. The DLS USB-COM
driver is
provided by Datalogic or downloaded from the Datalogic website.
1. Execute the DLS USB-COM driver file.
2. When the scanner is first plugged into the PC, Windows will bring up the
“Fou
nd New Hardware” message.
3. The installation is complete.
RS-232 Interface Selection
Remember to cover any unused bar codes on this and the facing page to ensure
that the scanner reads only the bar code you intend to scan.
CAUTION
000105(CR)
Interface Type = RS-232 Standard
000112(CR)
Interface Type = RS-232 Wincor-Nixdorf
000120(CR)
Interface Type = RS-232 Single Cable
Great care should be taken to select the correct interface type,
since you can cause damage to the scanner and/or POS terminal
by attempting to change to an incompatible interface. ALWAYS
make interface selections with the host cable DISCONNECTED.