Enter/Exit Programming Mode 1D Inverse Read Control
18 Magellan™ 3450VSi
1D Inverse Read Control
This configuration item is used to toggle inverted label reading for 1D bar
codes, for example, a label printed as white on black as opposed to black on
white.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and
the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by
scanning the Enter/Exit Pro-
gramming Mode bar code.
DEFAULT
1D Read Control = Disable
1D Read Control = Enable
To Next Page
Loading...
