Datalogic Magellan 3450VSi - Coupon Control; Coupon Control Enable

Enter/Exit Programming Mode Coupon Control Enable
114 Magellan™ 3450VSi
Coupon Control
Coupon Control Enable
This feature is used to control the method of processing coupon labels. For the
puposes of this feature, coupon labels are defined as:
1. UPC-A labels that start with a ‘5’
2. GS1 DataBar Expanded labels that start with ‘8110’
The options for this setting are:
• Disable — Coupon Control is turned off.
• Enable UPC-A Coupons — UPC-A coupon labels will decode b
ut GS1
DataBar Expanded coupon labels will not. GS1 DataBar Expanded labels
that are not coupon labels will decode and all UPC-A labels will decode.
• Enable GS1 DataBar Expanded Coupons — GS1 DataBar Expanded coupon
labels will decode but UPC-A coupon
labels will not. UPC-A labels that are
not coupon labels will decode and all GS1 DataBar Expanded labels will
decode.
To set this feature:
1. Scan the Enter/Exit Programming
Mode bar code.
2. Scan your choice from the Coupon Control selections below. You’ll need to
cover any unused bar codes
on this and the facing page to ensure that the
scanner reads only the bar code you intend to scan.
3. Complete the programming sequence by
scanning the Enter/Exit Pro-
gramming Mode bar code.
03B900(CR)
Coupon Control = Disable
03B901(CR)
Coupon Control = Enable UPC-A Coupons
DEFAULT
03B902(CR)
Coupon Control = Enable GS1 DataBar Expanded
Coupons