Codabar Length 2 Enter/Exit Programming Mode
Product Reference Guide
227
Codabar Length 2
If Codabar Length Control is set to Fixed-Length decoding, this feature speci-
fies Codabar second fixed length. If Codabar
Length Control is set to Variable-
Length decoding, this feature specifies the maximum label length.
NOTE
When in Fixed Length mode, if Length 2 is set t
o the value of 00
(zero), then only Length 1 will apply.
To set this feature:
1. Scan the ENTER/EXIT Prog
ramming Mode bar code.
2. Scan the bar code, Set Codabar Length 2 on page 227 below. You’ll need
to cover any unused bar codes on this and the facing pag
e to ensure that
the scanner reads only the bar code you intend to scan.
3. Scan the appropriate digits from the Alpha-Numeric Keypa
d in Appendix C
that represent the desired l
abel length. The selectable range for this
option is 00 (meaning ignore this length), or 03 to 50. Pad all single digit
numbers with a leading zero to yield a two-digit entry (03-50).
4. Complete the programming sequence
by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
Set Codabar Length 2
DEFAULT
Default setting for this feature = 32
To Next Page
Loading...
