Datalogic Magellan 3450VSi - Aztec Length Control; Configuring Variable Length Decoding

Aztec Length Control Enter/Exit Programming Mode
Product Reference Guide 279
Aztec Length Control
Fixed Length Decoding — When fixed length decoding is enabled, the scanner
will decode a bar code if the label length matches one of the configurable fixed
lengths.
Variable Length Decoding — When variable length decoding is enabled, the scan-
ner will decode a ar code if the label length falls in the range of the configurable
m
inimum and maximum length.
Configuring Fixed Length Decoding:
1. Scan the ENTER/EXIT Prog
ramming Mode bar code.
2. Scan the Fixed Length
Decoding bar code.
3. Scan the ENTER/EXIT Prog
ramming Mode bar code.
4. Set Length 1 to the first fixed length using the Aztec Length 1, Length 2
Programming Instructions on page 280 that follow this page.
5. Set Length 2 to the second fixed length (or t
o ‘0000’ if there is only one
fixed length) using the Aztec Length 1, Length 2 Programming Instruc-
tions on page 280.
Configuring Variable Length Decoding:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan the Variable Length Decoding bar code.
3. Scan the ENTER/EXIT Prog
ramming Mode bar code.
4. Set Length 1 to the minimum length using the Aztec Length 1, Length 2
Programming Instructions on page 280 that follow this page.
5. Set Length 2 to the maximum length using the Aztec Length 1, Length 2
Programming Instructions on page 280.
DEFAULT
043200(CR)
Aztec Length Control = Variable Length
043201(CR)
Aztec Length Control = Fixed Length