Product Reference Guide 55
Interface Related Features
USB-COM INTERFACE SETUP starting on page 57
•USB-COM Interface Setup on page 57
•RS-232 Interface Selection on page 57
•USB Interface Selection on page 58
•Keyboard Interface Selection on page 59
•Maximum Host-Transmitted Message Length on page 60
RS-232 INTERFACE FEATURES starting on page 61
RS-232 Interface Features on page 61
•RS-232 Baud Rate on page 61
•RS-232 Number of Data Bits on page 63
•RS-232 Number of Stop Bits on page 63
•RS-232 Parity on page 64
•RS-232 Hardware Control on page 65
•RS-232 Intercharacter Delay on page 66
•RS-232 Software Flow Control on page 67
•RS-232 Beep on ASCII BEL on page 68
•Beep on Not on File on page 68
•RS-232 ACK NAK Features on page 69
- ACK NAK Enable on page 69
- RS-232 ACK Character on page 70
- RS-232 NAK Character on page 71
- RS-232 Retry on ACK NAK Timeout on page 72
- RS-232 ACK NAK Timeout Value on page 73
- RS-232 ACK NAK Retry Count on page 74
- RS-232 ACK NAK Error Handling on page 75
•RS-232 Indicate Transmission Failure on page 76
•RS-232 Ignore Host Commands on page 77
SINGLE CABLE RS-232 FEATURES starting on page 78
•Single Cable RS-232 Shared Options on page 78
•Single Cable RS-232 RTS CTS Selection on page 79
•Single Cable RS-232 Use BCC on page 80
•Single Cable RS-232 Use ACK/NAK on page 80
•Single Cable RS-232 Use STX on page 81
- Set Single Cable RS-232 STX Character on page 82
•Single Cable RS-232 Use ETX on page 83
- Set Single Cable RS-232 ETX Character on page 83
•Single Cable RS-232 Datalogic Extensions on page 84
•Single Cable RS-232 Pacesetter Plus on page 85
USB-OEM INTERFACE FEATURES starting on page 86
•USB OEM Scanner Device Type on page 86
To Next Page
Loading...
