Datalogic Magellan 3450VSi - RS-232 ACK NAK Retry Count

Enter/Exit Programming Mode RS-232 ACK NAK Features
74 Magellan™ 3450VSi
RS-232 ACK NAK Retry Count
This feature sets the number of times for the scanner to retry a label transmis-
sion under a retry condition.
To set the RS-232 ACK NAK Retry Count:
1. Scan the Enter/Exit Programming
Mode bar code.
2. Scan the bar code, S
et RS-232 ACK NAK Retry Count below. You’ll need to
cover any unused bar codes on this and the facing page to ensure that the
scanner reads only the bar code you intend to scan.
3. Scan the appropriate digits from the Alpha-Numeric Keypad in Appendix C
that represent the desired number. The selectabl
e range is 000-255
resets. Pad all single and double digit numbers with leading zeroes to yield
a three-digit entry (000-255).
NOTE
A setting of 255 specifies “retry forever.”
4. The scanner will automatically exit Programming Mode when the appro-
priate amount of digits
have been scanned.
0608(CR)
Set RS-232 ACK NAK Retry Count
DEFAULT
Default setting for this feature is:
003 - Three retrys