Datalogic Magellan 3450VSi - Databar Omnidirectional Double Read Timeout

Enter/Exit Programming Mode DataBar Omnidirectional Double Read Timeout
170 Magellan™ 3450VSi
DataBar Omnidirectional Double Read Timeout
Specifies the minimum allowable time which must pass before reading the same
DataBar Omnidirectional label again (e.g. two identical items in succession).
To set this feature:
1. Scan the Enter/Exit Programming
Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and
the facing page to ensure that the scanner
reads only the bar code you intend to scan.
Complete the programming sequence by sca
nning the Enter/Exit Programming
Mode bar code.
00510A(CR)
DataBar Omnidirectional Double Read
Timeout = 0.5 Seconds
005114(CR)
DataBar Omnidirectional Double Read
Timeout = 1 Second
DEFAULT
005132(CR)
DataBar Omnidirectional Double Read
Timeout = 2.5 Seconds
00513C(CR)
DataBar Omnidirectional Double Read
Timeout = 3 Seconds
005146(CR)
DataBar Omnidirectional Double Read
Timeout = 3.5 Seconds