Datalogic Magellan 3450VSi - Good Read Beep Volume

Good Read Beep Volume Enter/Exit Programming Mode
Product Reference Guide 31
Good Read Beep Volume
Selects the beeper volume upon a good read beep. There are five selectable
volumes, with each volume increment adding approximately five decibels to the
previous level:
•Low •Medium High
•Medium Low •High
•Medium
To set this feature:
1. Scan the Enter/Exit Progr
amming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any unused bar
codes on this and the facing page to ensure that the scanner reads only the bar
code you intend to scan.
3. Complete the programming sequence by scann
ing the Enter/Exit Programming
Mode bar code.
001900(CR)
Good Read Beep Volume = Low
001901(CR)
Good Read Beep Volume = Medium Low
DEFAULT
001902(CR)
Good Read Beep Volume = Medium
001903(CR)
Good Read Beep Volume = Medium High
001904(CR)
Good Read Beep Volume = High