Datalogic Magellan 3450VSi - Code 32 Check Character Transmission

Code 32 Check Character Transmission Enter/Exit Programming Mode
Product Reference Guide 197
Code 32 Check Character Transmission
Enables/disables transmission of Code 32 check character.
NOTE
This item is ignored when the advanced feature, Full Label Edit, is
en
abled.
To set this feature:
1. Scan the ENTER/EXIT Prog
ramming Mode bar code.
2. Scan either the enable or disable bar code below. You’
ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence
by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
DEFAULT
00EF00(CR)
Code 32 Check Character Transmission = Disable
00EF01(CR)
Code 32 Check Character Transmission = Enable