Datalogic Magellan 3450VSi - Databar Omnidirectional 2 D Component Enable

Enter/Exit Programming Mode DataBar Omnidirectional 2D Component Enable
168 Magellan™ 3450VSi
DataBar Omnidirectional 2D Component Enable
When this feature is enabled, the software will not decode an DataBar Omnidi-
rectional bar code with a 2D component associated with it, and the 2D compo-
nent will be discarded.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and
the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence
by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
DEFAULT
04D600(CR)
DataBar Omnidirectional 2D Component = Disable
04D601(CR)
DataBar Omnidirectional 2D Component = Enable