Fuji Xerox ApeosPort 450 I

Send Options
137
Fax
4
Furthermore, notify the recipient of the following information for using the F Code
method to receive e-mail from the mailbox.
F Code (sub-address) : 0 (Display F Code transmission) and the storage
mailbox number.
Password (if necessary) : Password of the mailbox in which e-mail is stored.
Note • Mailbox reception using the DTMF method is possible, but the only signals that can be
received are numerals, ∗, and #.
• It may be possible to automatically print a document received in the mailbox depending on
the mailbox settings. For information on settings for mailboxes, refer to "Mailbox" (P.336).
• Depending on the report print settings, the Mailbox Documents Report may not be printed
even if e-mail is received in the mailbox. For information on setting the report print settings,
refer to "Reports" (P.277).
For information on printing received documents, refer to "Printing/Deleting Documents in the Mailbox"
(P.198).
Sending to Mailbox (F Code Method)
1 Select [F Code] on the [Send
Options] screen.
2 Select [On].
Off
The F code transmission is not used.
On
The F code transmission is used. Enter the F Code.
F Code
Enter the F code using the numeric keypad.
Note • You can enter up to 20 digits for the F Code.
Password
Enter the password using the numeric keypad. If a password has not been set, you do
not need to enter one.
Note • You can enter up to 20 digits for the password.
Next
Select this button after entering [F Code] or [Password].
Private Polling (F Code Method)
1 Select [F Code] on the [Send
Options] screen.
2 Select [On].
3 Enter the F Code with the numeric
keypad and select [Next].
Note • You can enter up to 20 digits for the F Code.
4 If necessary, enter the password using the numeric keypad and select [Next].
Note • You can enter up to 20 digits for the password.