3 Copy
92
Copy
3
Features that can be set in Build Job
Finishing
For information on the feature, refer to "Finishing (Outputting by Specifying Finishing)" (P.73).
Booklet Creation
For information on the feature, refer to "Booklet Creation (Creating a Booklet)" (P.75).
Covers
For information on the feature, refer to "Covers (Attaching a Cover to Copies)" (P.77).
Annotation
For information on the feature, refer to "Annotation (Adding Stamp/Date/Page Number to Copies)"
(P.82).
Set Numbering
For information on the feature, refer to "Set Numbering (Printing Control Number on the Background)"
(P.86).
[Copy Job] Screen
The following describes the screen that appears while the Build Job is being executed.
Chapter Start...
Displays the [Build Job - Chapter Start/Separators] screen.
Refer to "[Build Job - Chapter Start/Separators] Screen" (P.93).
Change Settings...
The Copy screen appears and you can change the settings for the loaded document.
After setting the features, press the <Start> button on the control panel to start
scanning of the document.
Cancel
The document data stored by the Build Job feature is cleared and the job is canceled.
Note • The same operation is performed if you press the <C> button or <Clear All> button on the
control panel.
Last Original
Select this item to end scanning of documents. The build job starts.
Next Original
Select this item when you have another document. This item is selected when using
the Build Job feature.
Start
When you load the next document and press the <Start> button, the machine starts to
scan the loaded document.
Note • The same operation is performed if you press the <Start> button on the control panel.
To Next Page
Loading...
