11 System Settings
358
System Settings
11
System Administrator Password
You can set the password for the System Administration mode.
Setting a password is strongly recommended for security.
Note • The default system administrator password is “x-admin”.
The system administrator password becomes valid when the password feature is
activated in the Login Setup/Auditron Administration operation. Set the password after
setting the system administrator user ID.
You can set the password from 4 to 12 numeric digits.
For information on enabling and disabling passwords, refer to "Password Entry from Control Panel"
(P.365).
1 Select [System Administrator
Password].
2 Select [Keyboard].
3 Enter a new password from 4 to 12
numeric digits in [New Password],
and select [Next].
4 In [Re-enter Password], enter the same password, and select [Save].
Note • To set no password, leave the password blank, and select [Save].
Maximum Login Attempts
If authentication of the system administrator user ID fails repeatedly, you can set a limit
beyond which further tries are not allowed.
You can set the number of authentication attempts allowed, from 1 to 10.
Note • The count is reset when the machine is restarted.
• To chancel the access rejection state, restart the machine by turning off and on the power.
1 Select [Maximum Login Attempts].
2 Select [On].
3 With [ ] and [ ], set the number
of authentication attempts allowed.
4 Select [Save].
To Next Page
Loading...
